top of page

ARTEMIS IN-LINE HOP INFUSER

MSASTEMIS
R2 890.00
In-Line Hop Infuser and Filter
In stock
1
Product Details

The Artemis In-Line Hop Infuser has been manufactured from 316 and 304 Stainless Steel and comes standard with Camlock Fittings.

The Artemis In-Line Hop Infuser allows the Brewer to add Hops in either pellet or cone form whilst performing In-Line Hopping at any point in the mashing, boiling or cooling stage of a brew.

Under the Top Inlet is a Diffuser Plate, which sits on top of the Hop Basket. The Diffuser Plate will allow the spread of the wort evenly over the Hop Basket. The large Hop Basket can accommodate Cone Hops, however when using Pelleted Hops, we suggest that no more than 300g is used due expansion. A brew bag or cloth can be used in conjunction with Rice hulls in the system. This will help improve removal of hop matter into the fermenter.

Additional Information:

The Artemis In-Line Hop Infuser has been designed and built by Millside. If any additional Hoses and Camlock Fittings are required, they can be purchased directly from Millside and will accommodate most Brewing Systems.

The Artemis In-Line Hop Infuser can also be used as a Inline Filter to remove unwanted Hops or Grains from the Brew before being pumped into the Fermenter. To do this simply attach the Artemis In-Line Hop Infuser inline after the pump, fill with Rice Hulls and the Filter is ready for use.

The Artemis In-Line Hop Infuser allows a high flow rate and will not imped the flow rate of the pump.

PLEASE NOTE:

PRODUCT WARNING . . . THIS PRODUCT REQUIRES THE USE OF PROTECTIVE GLOVES AS THE UNIT CAN GET EXTREMELY HOT!

Including:

1 x Main Body - 304 Stainless Steel which is Purge Welded with a Female Camlock Fitting - 4"

1 x Lid Gasket - 4"

1 x Lid with Male Camlock Fitting

1 x Tri-Clover Clamp - 4"

1 x Diffuser Plate with Eye-Bolt

1 x Internal Hop Basket

Operation Instructions:

Sanitize and Clean the Unit Before Use

Attach the Inlet and Outlet Hoses to the Unit - The Top of the Unit is the Inlet and the Bottom is the Outlet

Fill the Hop Basket with the Desired amount of Hops, adding Rice Hills in layers.

Insert the Diffuser Plate with Eye-Bolt, Gasket and Lid.

Tighten the Tri-Clover Clamp and Attach the Hoses to the Pump System and Outlet.

PLEASE NOTE:

Please ensure that the Artemis In-Line Hop Infuser is placed at a higher level than the Artic Counterflow Chiller or Fermenter to allow for complete drainage.

Cleaning and Maintenance:

Remove the Hoses and Drain any Remaining Wort out of the Unit.

Remove the Tri-Clover Clamp, Gasket and Diffuser Plate.

Remove the Hop Basket and Rise out the Hops.

Clean the Housing

Sanitize and Dry All Parts

Re-Assemble Unit


Save this product for later
bottom of page